Vintage rock tones with modern features and high gain!
The Marshall Vintage Modern 2466 Half Stack includes the Vintage Modern 2466 Tube Amp Head and Vintage Modern 425A angled speaker enclosure.
The Marshall Vintage Modern 2466 Tube Amp Head is an all valve amplifier with a choice of two dynamic ranges selectable by footswitch. The Low range delivers the performance you would expect from a stock vintage Marshall amplifier in terms of tone and available gain. The High range adds an extra preamp valve into the signal path, facilitating those classic hard rock tones of the seventies. Add to this the ability to dynamically interface with your instrument's Volume and Tone controls and the experience translates into a truly expressive and organic feel in performance.
Two frequency selective Pre amp Volumes (Gains) Body and Detail facilitate greater flexibility in tone shaping for individual guitars and styles while the power amplifier is heavily influenced by the first Marshall amplifiers to be produced, with four KT66 output valves yielding that substantial, fat and smooth tone. A MID Boost switch on the front panel fattens the tone even more while a traditional Marshall tone control circuit enables fine tuning of your sound.
A master volume has been included in order to practically manage the output levels at all venues. This is implemented after the phase splitter in order to fully exploit maximum preamp drive when the master is turned down low. A reverb level control mixes the on board plate reverb with the direct signal to whatever degree the player chooses. The reverb can be toggled on and off via the footswitch.
Finally, a series FX loop is provided for those players who wish to use outboard effects to further enhance their sound. Loop levels of 10dB and +4dB can be controlled via a rear panel switch as well as the option to completely bypass this feature if it is not required.
The cosmetics are also a carefully crafted hybrid of old and new styles made even more dramatic by the deep purple vinyl that covers the entire series.
The Marshall Vintage Modern 425A angled speaker cab is a traditional Marshall 4 x 12 speaker cabinet in design. Mono/stereo switchable and loaded with G12C 25 Watt Celestion Greenbacks, this was specifically developed for the Limited Edition Jimi Hendrix Super100JH stack and are voiced to give that rich and balanced harmonic timbre that complements vintage tone and the Vintage Modern Series perfectly.
The cosmetics are also a carefully crafted hybrid of old and new styles made even more dramatic by the deep purple vinyl that covers the entire series.
Marshall 2466 and 425A or 425B Half Stack Specifications:
- Head Dimensions: 29 1/2" x 12" x 9" (750 x 310 x 230 mm)
- Weight: 49.6 lbs (22.5 kg)
Cabinet
- Impedance
- Mono 16 Ohms/4 Ohms
- Stereo 8 Ohms/8 Ohms
- Dimensions 30.5" x 30" x 14.5" (770 x 755 x 365 mm)
- Weight
- 425A: 79 lbs. (36 kg)
Marshall 2466 and 425A or 425B Half Stack Features:
- 100 Watt valve head
- Valve compliment: 4 x ECC83 (12AX7s) in preamp, 4 x KT66 in power amp
- Master Volume with two Gain Controls Detail (highs) & Body (lows)
- Two changeable with footswitch Dynamic Ranges Low & High
- Mid Boost switch
- changeable with footswitch Proprietary digital Plate Reverb
- Series FX loop with level switch and bypass
- Made in England
100 Watt, 4x12" cabinet
- Angled front
- Loaded with Celestion G12C 25 Greenbacks
- Mono or Stereo switchable
- 16 Ohms/4 Ohms mono
- 8 Ohms stereo
- Birch ply construction
- "finger locking" joints
- Made in England
This half stack rocks with its classic Marshall sound and modern high gain edge! Make it yours. Order yours now and take advantage of these incredible savings!
